Version 6.37.0.0 of Flex out now
A new protocol adds up toFlex‘s vehicle list: from today on, you can work onHitachi BED 434 ECUsin OBD mode.
Elaborate engine parameters of vehicles fromRenaultorNissanby accessing the map zone directly from the diagnostic port of the vehicle.
With this new solution, you will no longer need to remove the engine unit from the vehicle, therefore being able to easily and rapidly program in OBD.
Some of the supported vehicles
- Nissan Juke 1.6L Nismo 185PS
- Nissan Qashqai 1.6L DIG-T 165PS
- Renault Clio RS 1.6L TCe 200PS
- Renault Kadjar 1.6L TCe 165PS
- Renault Megane IV 1.8L TCe 225PS
- Renault Talisman 1.6L TCe 200PS
This new protocol is available for the following software packages
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols
(OBD)
- Renault / Nissan Hitachi BED434 Read/Write/Checksum Calculation Maps
Reading Time ~ 2 minutes and 30 seconds Writing Time: ~ 1 minute and 30 seconds
Bug fixes
- Added new CRC type for Abarth Bosch ME17.3.0
- Added new CRC type for Volvo Bosch EDC7C1
- Added new CRC type for FCA Marelli MM10JA
- Added new CRC types for Mazda Melco E6T
Software improvements
- Added OBD Full and Bench Support for Mazda SHxx SH72546
