Flex Version 7.33.0.0 and New StageX Update Ready
With the release of Flex software version 7.33.0.0, OBD programming is now available for Bosch VD1CP110 control units, used in the management of AdBlue systems.
In just a few minutes, you can now have direct access to the ECU calibration data through the diagnostic port, or, if the vehicle is not available, you can also proceed via the ECU connector.
Supported Vehicles
-
Ford Ranger IV 2.0L EcoBlue 170PS
-
Ford Tourneo Customer II 2.0L EcoBlue 140PS
New protocol available for the following software packages:
OBD
-
FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
-
FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
-
FLS0.5M – SW Flex Full Master
-
FLS0.5S – SW Flex Full Slave
Newly added protocols:
OBD
-
Ford Bosch VD1CP110 TC375 Read/Write/Checksum Calculation Maps
